Hi there,
I'm not well known with electronics but i'm trying and experimenting a lot right now. For the moment i'm simulating an LFSR Parallel in; Serial out.
I did this as follows:
When converting this circuit to a new symbol, which i can set up with a clock pulse and D0 to D3 input signals. I get:
Again, i'm only using spice for a week right now, so all feedback is welcome!
When i'm trying to run the simulation i get the following error:
Thanks in advance!
I'm not well known with electronics but i'm trying and experimenting a lot right now. For the moment i'm simulating an LFSR Parallel in; Serial out.
I did this as follows:
When converting this circuit to a new symbol, which i can set up with a clock pulse and D0 to D3 input signals. I get:
Again, i'm only using spice for a week right now, so all feedback is welcome!
When i'm trying to run the simulation i get the following error:
Thanks in advance!