Hello,
I have a motor and controller from a treadmill I would like to re-purpose as a bandsaw motor. The controller is made by Pulse Power Systems who I believe is out of business. The model number is QQ2245. I found a service manual for the treadmill that tells me it has a PWM input pin I can use to drive it. Does anyone have any info on how to control this? The PWM circuit chip (SG3526) will be expecting a certain PWM frequency. I see user IamJatinah has mentioned knowing something about these controllers, but I can't seem to message him. Maybe I don't have enough posts?
Anyone have any ideas?
Thanks,
Jeff
I have a motor and controller from a treadmill I would like to re-purpose as a bandsaw motor. The controller is made by Pulse Power Systems who I believe is out of business. The model number is QQ2245. I found a service manual for the treadmill that tells me it has a PWM input pin I can use to drive it. Does anyone have any info on how to control this? The PWM circuit chip (SG3526) will be expecting a certain PWM frequency. I see user IamJatinah has mentioned knowing something about these controllers, but I can't seem to message him. Maybe I don't have enough posts?
Anyone have any ideas?
Thanks,
Jeff