Issue with a marshall Kilburn 1 Speaker

Thread Starter

IKBEAIHKBDUIbd

Joined Jan 9, 2026
1
Hello everyone,
I recently aquired a marshall Kilburn speaker on a retail website which said it was properly working.
The issue is that it isn't, I asked the guy who sold it to me and he said he used it mainly on sector because the battery wasn't working (15-20 minutes autonomy instead of multiple hours).
The issue is that the battery works fine (I charged it separately using a generator and it works fine) but the main power circuit seems to completely offline for some reason.
When I plug in the speaker it doesn't charge by itself the battery, but works perfectly with the battery charged, I opened it up and the entry fuse and thermistance were respectively showing 13 Ohm (the model is a NTC 10D-9) and 0.2 Ohm (not blown).
Therefore I believe the issue might be lying in the power supply circuit but it could be anywhere else.

I have spent multiple hours trying to figure it out, asking AIs also but I can't seem to find anything useful so I would appreciate it very much if any of you guys helps a bit in this case.

Thank you in advance
 

Attachments

Hello, have you been able to troubleshoot this, I just encountered the same issue on my Kilburn 1 Speaker, entry fuse is fine, works from a battery, but no mains/charging. It appears the AC circuit is closing as you can hear a faint zap when plugging it in, but charging or mains alone does not work.
 

Pyrex

Joined Feb 16, 2022
578
Hi,
first of all, power up the device from the mains. It looks like a big black electrolytic capacitor, 47uF 400V, is connected to the diode bridge + and -, then check the DC voltage across its terminals. It should be around 160V if mains is 120VAC or 320V if mains is 230V.
If voltage is found OK, found U1 IC datasheet. I suggest, it is a PWM controller. Find the typical application diagram in the datasheet, it will roughly match your PCB diagram, and check the voltages according to this diagram
 
Top