I have a pad-234 analog/digital trainer which smoked and sparked backed to back with about 1/2 minute in between each occurance. I followed the instructions before performing the assignment. I was performing the reading of the current from the voltage from one resistor to another.
My professor said i blow a fuse in the dmm reader because i could no long get a correct reading. I replaced the fuse in the dmm and it worked fine on two assignments, but during the third assignment the dmm fuse blow out again. I am following instruction, so I think its the breadboard. I believe that when it smoked and sparked iit damaged the pad-234 analog/digital.
Am I correct. I can not afford to keep replacing the fuse in the dmm reader.
where am I going wrong.
Please help.
My professor said i blow a fuse in the dmm reader because i could no long get a correct reading. I replaced the fuse in the dmm and it worked fine on two assignments, but during the third assignment the dmm fuse blow out again. I am following instruction, so I think its the breadboard. I believe that when it smoked and sparked iit damaged the pad-234 analog/digital.
Am I correct. I can not afford to keep replacing the fuse in the dmm reader.
where am I going wrong.
Please help.
Last edited: