I have an FPGA generating a 5MHz square wave at 3.3v being received by a register/counter. At the transitions, I see bounce. It is large enough that my data logger sees extra transitions.
My goal is to use a resistor and cap to clean the transitions. I therefore want to use Tina to mimic the ~50-100 MHz bounce over a 5MHz signal and fix it. I can then pick my R and C, check my circuit, and then fabricate a circuit. How do I get my Tina square wave circuit to bounce at the transitions?
My goal is to use a resistor and cap to clean the transitions. I therefore want to use Tina to mimic the ~50-100 MHz bounce over a 5MHz signal and fix it. I can then pick my R and C, check my circuit, and then fabricate a circuit. How do I get my Tina square wave circuit to bounce at the transitions?