how to run third party MCP6001 LT spice models in LT spice

Status
Not open for further replies.

tomlindm

Joined Nov 7, 2017
2
The factory model of this opamp is poorly suited for LTspice.
I made a correction for this model.
And
http://www.analog-innovations.com/
MCP6001_JT.zip
This "corrected" model does not seem to account for the output saturation at the lower rail (0V) when using a single power supply. The minimum output voltage that the op amp can produce is 25mV according to the datasheet.

Texas Instruments has a generic equivalent to the MCP6001, called the TLV6001. The TI model is available on their website and works with LT Spice's opamp2 symbol without any need for modification. Just copy the TLV6001.txt model file into the project directory and add the spice directive ".inc TLV6001.txt" to the LT Spice schematic.

* You can search for the TLV6001 on TI.com
 

tomlindm

Joined Nov 7, 2017
2
tomlindm.
You mean the model corrected by me? Or do you mean MCP6001_JT.zip?
Hi. I only tested your corrected model, yes. The original model does not run in LT Spice so I could not compare yours against the original.

The TI TLV6001 model is a suggestion as an alternative that I found worked well. It should produce fairly similar results to the MCP6001. When I have time, I will see if I can post the test circuit with results using the different models just to confirm that the problem is not with the keyboard actuator.
 

Bordodynov

Joined May 20, 2015
3,432
I learned how to work with the original, factory model. Could you download the file with which you found a drawback? And also a circuit with a chip from TI. I want to compare the factory model and the model corrected by me.
 
Hello:
I've found an error in the MCP6001.LIB provided by "Bordodynov", whom I graciously thank for providing all his/her work to the community for *free*. The error is on line 133 and reads "BD52 52 0 v=-uarmp(v(50))". This should be "BD52 52 0 v=-uramp(v(50))".

Peace and blessings,
Johnny Quest
 
Hi Bordodynov:
I promise I didn't change it. :)

Did you look at the file and is the typo error there or is yours correct?

Peace and blessings,
Johnny
 
Status
Not open for further replies.
Thread starter Similar threads Forum Replies Date
M Homework Help 4
Top