All About Circuits

how to change reference probe of oscilloscope in Proteus

R

Thread Starter

Rusty Rifle

Joined Dec 18, 2019
18
hi all♥
I want to measure the voltage between two points non of them is the ground
how can I do it in proteus ?
 
Last edited by a moderator:
Danko

Danko

Joined Nov 22, 2017
1,834
Rusty Rifle said:
hi all♥
I want to measure the voltage between two points non of them is the ground
how can I do it in proteus ?
Click to expand...
1. Use DC (or AC) voltmeter.
2. With oscilloscope, using inputs of 2 channels.
Two inputs can be summed by using A+B or C+D buttons.
Using Invert button each channel may be inverted.
 
Last edited:
You must log in or register to reply here.
Thread starter Similar threads Forum Replies Date
M Change Normally Open to Normally Closed for Security Camera General Electronics Chat 1
M Change the working of Dahlander Electric motor Power Electronics 3
Amasif Can we change firmware of neckband. Microcontrollers 2
D Looking to change my twerking Santa’s music General Electronics Chat 0
F How to Change Signal Voltage reference from AGND to GND Power Electronics 1
Similar threads
Change Normally Open to Normally Closed for Security Camera
Change the working of Dahlander Electric motor
Can we change firmware of neckband.
Looking to change my twerking Santa’s music
How to Change Signal Voltage reference from AGND to GND

You May Also Like

Top