hello,
I have an air coil about 70ohm and 2H. I would like to send an Amplitude modulation (AM) signal at 600v.
What type of circuit would I need ? CS ? CG ? should I use a JFET or MOSFET ?
I have some ideas on how to do it but the simulation so far have to given me anything positive to pursue.
Thanks for any of your ideas.
Ken
I have an air coil about 70ohm and 2H. I would like to send an Amplitude modulation (AM) signal at 600v.
What type of circuit would I need ? CS ? CG ? should I use a JFET or MOSFET ?
I have some ideas on how to do it but the simulation so far have to given me anything positive to pursue.
Thanks for any of your ideas.
Ken
Last edited: