Hey everyone,
I just finished soldering a special noise machine for a friend of mine to use for his live performances. I wanted to get some advice on what kind of material I should use for housing my circuit board and what I should be aware when I'm making this decision. I just want to make sure that whatever I decide to use doesn't short out my project.
As far as the size, the board I used was an Adafruit (5 x 3 x 0.5 inches). I will have to drill some holes for four potentiometers, an LED and a 9V (DC) jack.
Any advice would be fantastic.
Thanks,
Sam
I just finished soldering a special noise machine for a friend of mine to use for his live performances. I wanted to get some advice on what kind of material I should use for housing my circuit board and what I should be aware when I'm making this decision. I just want to make sure that whatever I decide to use doesn't short out my project.
As far as the size, the board I used was an Adafruit (5 x 3 x 0.5 inches). I will have to drill some holes for four potentiometers, an LED and a 9V (DC) jack.
Any advice would be fantastic.
Thanks,
Sam
Attachments
-
285.8 KB Views: 22