Hi all,

I have a 32mmx18mm board ready to be printed, but the fabrication house minimum print area is 100mmx100mm. This wastes a lot of space available in the PCB. How do I create a gerber with the same (and multiple) PCB design so that I can fill up all the empty spaces?

Best Regards,
Nick

 

Copy paste, fill the PCB and generate the gerber.

 

When you copy, make sure that all the layers are on when you make your selection. Then close that design, then open the PCB design that you want to Gerber and paste the original PCB where you want.

 

Copy paste, fill the PCB and generate the gerber.

Thanks, I didn't realize I have to create a new .brd file, thanks a lot!

When you copy, make sure that all the layers are on when you make your selection. Then close that design, then open the PCB design that you want to Gerber and paste the original PCB where you want.

Thanks for the advice! I would have forgotten to turn on all the layers without your advice lol