Gap in net error removal

Thread Starter

hunterage2000

Joined May 2, 2010
487
Hello all, I am trying to get to grips with Designspark 7.2 and am having trouble getting rid of small unconnected islands that are on the same ground plane (See attached image).

I have tried the following:

1). Delete the islands

2). Disconnect the islands from GND net

3) Change their shape type to board

When the copper is cleared then re-poured they just come back

Can anyone help me with this please?

Thanks in advance
 

Attachments

eetech00

Joined Jun 8, 2013
3,856
Hello all, I am trying to get to grips with Designspark 7.2 and am having trouble getting rid of small unconnected islands that are on the same ground plane (See attached image).

I have tried the following:

1). Delete the islands

2). Disconnect the islands from GND net

3) Change their shape type to board

When the copper is cleared then re-poured they just come back

Can anyone help me with this please?

Thanks in advance
Hi

Check the rules for track to track, track to pad and pour spacings. Sometimes the spacings are to large and pours won’t complete between pin pads.

eT
 
Top