I have a few questions regarding a pic16F690 and a rf digital 21733 rf transceiver I have been learning with. In the rf datasheet for the 21733 it states that the data rate is "9600 baud 8 bits no parity and 1 stop bit", and they say that it is half duplex. Now from what I have seen, half duplex (synchronous) does not have a stop bit and full duplex (synchronous) does have a stop bit.
My questions:
1: Why does the rfdigital 21733 manual state half duplex and 1 stop bit?
a: Which one is it?
2: I need to use the rf 21733 with the pic 16f690 in which mode? half or full? Because the rf 21733 states: 9600 baud 8 bits no parity and 1 stop bit should I think off this as full duplex?
I am just confused as to what they are asking for here?
I have done full duplex before between picks w/ no problem but now want to do EUSART between pics w/ the rf21733 to have wireless communications.
I am seeking another set of eyes here to figure out what it should be.
Thanks all for your help.
My questions:
1: Why does the rfdigital 21733 manual state half duplex and 1 stop bit?
a: Which one is it?
2: I need to use the rf 21733 with the pic 16f690 in which mode? half or full? Because the rf 21733 states: 9600 baud 8 bits no parity and 1 stop bit should I think off this as full duplex?
I am just confused as to what they are asking for here?
I have done full duplex before between picks w/ no problem but now want to do EUSART between pics w/ the rf21733 to have wireless communications.
I am seeking another set of eyes here to figure out what it should be.
Thanks all for your help.