Dear Expert
I bought my Fluke MS2-TTK MicroScanner2 Network Cable Tester Kit from ebay on November 2017 and it is brand new.
Today I was trying to use “Wire Map” mode that is located on its probe the LED light supposed to be jumping between number 1 to 8 to show wire mapping is okay as per below :
Check @ 55 sec
Mine stuck at number one ,,,,I want to find out if that indicate a problem or something else ?
I bought my Fluke MS2-TTK MicroScanner2 Network Cable Tester Kit from ebay on November 2017 and it is brand new.
Today I was trying to use “Wire Map” mode that is located on its probe the LED light supposed to be jumping between number 1 to 8 to show wire mapping is okay as per below :
Check @ 55 sec
Mine stuck at number one ,,,,I want to find out if that indicate a problem or something else ?
Last edited: