Hi,
I am sorry if my question is related to other posts, If so please point it out to me.
I am trying to make my own electronic load using ESP32, I am going to use either multiple IRFP260N or IXTK90N25L2 as the load mosfet. My question is
I am using a 50 amp 75 mv shunt and planning to use a 12bit DAC for the control signal and the attached schematic for the circuite.
As I am trying to enhance the control so I want to use an amplifier for the current measuring voltage signal (before the shunt).
Is this circuite correct or I have to add more elements.
Please note that my specialization is not electronics
I am sorry if my question is related to other posts, If so please point it out to me.
I am trying to make my own electronic load using ESP32, I am going to use either multiple IRFP260N or IXTK90N25L2 as the load mosfet. My question is
I am using a 50 amp 75 mv shunt and planning to use a 12bit DAC for the control signal and the attached schematic for the circuite.
As I am trying to enhance the control so I want to use an amplifier for the current measuring voltage signal (before the shunt).
Is this circuite correct or I have to add more elements.
Please note that my specialization is not electronics