Hi, I am not sure if this is the right place to post about this, but if not please could anyone suggest where to post?
The problem is that today, I connected up my two AVR4809s as usual to my NUC6cAYH and there was a problem which fried the power cabling attached to an FTDI I use for serial comms with the 4809. The USB ports on the NUC no longer work. Is there anything I can do to resurrect the USB ports?
thanks very much for thoughts.
Paul
The problem is that today, I connected up my two AVR4809s as usual to my NUC6cAYH and there was a problem which fried the power cabling attached to an FTDI I use for serial comms with the 4809. The USB ports on the NUC no longer work. Is there anything I can do to resurrect the USB ports?
thanks very much for thoughts.
Paul