I am in need of an Electronics Clips that looks similar to the picture below. However, I need it to be much skinnier, preferably 2 mm, and shorter, about 2 to 3 cm. Also it needs to be conductive and sturdy. If anyone can point me the right direction, that would be extremely helpful.

 

Welcome to AAC.

Could you explain the application? It could help in finding something appropriate.

 

Trying to Connect battery as shown in the bottom picture to this PCB, the battery needs to be interchangeable. I have a previous system using alligator clips and wiring, and it works but there are complaints that its a bit messy and confusing, preferably want to make something I can just slide in.

 

I suggest looking at the product catalog of the "Keystone" company. They specialize in battery connection hardware.

 

Harwin has these, and variations, designed for surface mount. My concern would be ohmic contact issues though that‘s conjecture. Clearly you woul have to bend them a bit. A jig that fit an ribbon cable IDC crimping tool could probably do it repeatedly.

​