Wrong pin? 7
View attachment 258274

Yes, no.7.

 

So does it work for you?

 

So does it work for you?

As I said, it cuts output at 13.7V. Before I desoldered that leg, it wouldn't even turn on with 1k resistor.

 

Strange, nothing changes to me. 12.44v as before, if I insert resistance the fans accelerate and ovp actived

 

Maybe you made a different connection?

 

Maybe you made a different connection?

I haven't touched anything else. Can you post a pic of what you did?

 

Pin7 cut and 1k resistor not connected, OVP intervenes as soon as I connect

 

View attachment 258340View attachment 258341
Pin7 cut and 1k resistor not connected, OVP intervenes as soon as I connect

I can't see very well. Where's the leg? Did you break it off? Or tucked it under?
Make sure all surrounding connections are fine, add solder if needed. Because I see it wasn't very tidy job you did there

 

I can't zoom in, pin n ° 7 (penultimate below) is disconnected

Mod: zoomed in.

 

I can't zoom in, pin n ° 7 (penultimate below) is disconnected

Other link is: Connect PS ON and PS Kill to ground to power up.
1k resistor between ground and 12VS

 

I have no clue why it's working for me and isn't for you.
I'm about to give up on this device as 13.7 isn't enough for me.
I'm gonna buy a device that I'm familiar with.
Will be following this thread in case someone finds a solution. I have no competences to do any further
research.
Good luck!

 

hi all i no this is a hold thread did any one ever get this to work. or did you give upi have read all the thread does not point to what people have done did you cut connector add resistor soldered wire on any help