DB LTC6811 with Arduino Uno

Thread Starter

Lorenzo Ruscitti

Joined Nov 12, 2018
13
Hi everyone

I'm trying to communicate with the LTC6811 demo board.

I connected directly from the Arduino pins to the J2 connector on the demo board.

Arduino - LTC J2

D13 (SCK) - SCK
D12 (MISO) - SDO (pull up with 5k)
D11 (MOSI) - SDI
D10 (CS) - CSB

Also I put the jumpers JP2, JP1, JP3 in the zero position, because I want to use the 4-wire SPI.

I monitored the MOSI line with the oscilloscope but I am not receiving anything.

I always get back that there is a problem with the PEC.

Can you help me ?

Thank you
 

Thread Starter

Lorenzo Ruscitti

Joined Nov 12, 2018
13
Hi

i see this , but i this guide they are using Linduino and analog device tool and Arduino tool to use Serial monitor. I want to write my customize code with using of Analog LTC library. i don't have Linduino but i'm using my Arduino uno.

Thank you
 
Top