Hello All,
I'm wiring a circuit and I was just wondering what the general opinion is.. This isn't on a board, its in an enclosure for a control panel I'm building. I need to put some resistors between some 18-22AWG stranded copper wires. What do ya'll think is the best way to do this? Should I just wire nut them all, should I solder and heat shrink them, or can I just put some crimp connectors on either side of the resistors and crimp the leads to the wires..Or is there some other, easier, and cheaper way? Just wondering what you all think.. one end of the resistors could just go into screw terminals, but I still have to go from there..
-Thanks
I'm wiring a circuit and I was just wondering what the general opinion is.. This isn't on a board, its in an enclosure for a control panel I'm building. I need to put some resistors between some 18-22AWG stranded copper wires. What do ya'll think is the best way to do this? Should I just wire nut them all, should I solder and heat shrink them, or can I just put some crimp connectors on either side of the resistors and crimp the leads to the wires..Or is there some other, easier, and cheaper way? Just wondering what you all think.. one end of the resistors could just go into screw terminals, but I still have to go from there..
-Thanks