hello all, Im currently working on a project which involves moving 2 motors and one servo with one circuit connected to an Arduino. I am reverse-engineering a similar idea found online, and am coming by trouble.
I'm a mechanical engineering major, so circuits aren't my specialty! Any help is appreciated, I have a good idea on the relay wiring, but there's some parts that stump me!
FRONT
REAR
RELAY, MOTOR, ARDUINO WIRING. These numbers are based off of the NEXT photo.
RELAY WIRING FOR 2 MOTORS
Text describing above wires. NOTICE: one sentence mentions that pin 5 is threaded through a hole and soldered to terminal 5. A different sentence shares that the pin 5 was connected to the negative terminal. Help!
CLUSTER**** , half of the wiring?
Possible Terminals? Who knows.
Beyond me!
I'm a mechanical engineering major, so circuits aren't my specialty! Any help is appreciated, I have a good idea on the relay wiring, but there's some parts that stump me!
FRONT
REAR
RELAY, MOTOR, ARDUINO WIRING. These numbers are based off of the NEXT photo.
RELAY WIRING FOR 2 MOTORS
Text describing above wires. NOTICE: one sentence mentions that pin 5 is threaded through a hole and soldered to terminal 5. A different sentence shares that the pin 5 was connected to the negative terminal. Help!
CLUSTER**** , half of the wiring?
Possible Terminals? Who knows.
Beyond me!
