All About Circuits

Connecting SD-card holder to Arduino Giga

Search Forums New Posts
R

Thread Starter

Rensieboy223

Joined Feb 3, 2024
88
Hello Guys,

I'm trying to connect my SD-card holder to my arduino giga.
They run both on 3,3V so I don't need a voltage Voltage regulator.
This is my schematic so far, are there any changes/improvement needed:
1722583369752.png

I want to custom intergrate this in my own pcb, so i'm not interested in a SD-card module.

Thanks already!
 
You must log in or register to reply here.
Thread starter Similar threads Forum Replies Date
Mussawar Connecting DC BUS (-V) of two VFDs at single point. Analog & Mixed-Signal Design 10
S Connecting LiPo, wall wart, and project in parallel Power Electronics 4
C connecting a 4 wires/lines 3.5 female jack plug with a one wired speaker General Electronics Chat 5
D Connecting Arduino to the internet via 4G with Sim card Microcontrollers 1
G Connecting Analog O/P Card Signal to Digital I/P Card Digital Design 0
Similar threads
Connecting DC BUS (-V) of two VFDs at single point.
Connecting LiPo, wall wart, and project in parallel
connecting a 4 wires/lines 3.5 female jack plug with a one wired speaker
Connecting Arduino to the internet via 4G with Sim card
Connecting Analog O/P Card Signal to Digital I/P Card

You May Also Like

Top