All About Circuits

Connecting an opto couplers input led in series with the collector of a bjt

Search Forums New Posts
Y

Thread Starter

Yami

Joined Jan 18, 2016
354
Hi, I was wondering if I could connect the opto couplers or opto diac input as shown in the picture. Because normally I don't see it connected like that. But technically it should work shouldn't it? The simulation works

Darksensing circuit1.jpg
 
You must log in or register to reply here.
Thread starter Similar threads Forum Replies Date
mirandasofty06 Powering a photomultiplier tube, connecting it to Arduino with voltage amplifiers and resistors; to build a cosmic ray detector wit scintillation Homework Help 10
Mussawar Connecting DC BUS (-V) of two VFDs at single point. Analog & Mixed-Signal Design 10
S Connecting LiPo, wall wart, and project in parallel Power Electronics 4
C connecting a 4 wires/lines 3.5 female jack plug with a one wired speaker General Electronics Chat 5
shlinie connecting the blocks of the electrical circuit of the Muller Geiger counter? General Electronics Chat 7
Similar threads
Powering a photomultiplier tube, connecting it to Arduino with voltage amplifiers and resistors; to build a cosmic ray detector wit scintillation
Connecting DC BUS (-V) of two VFDs at single point.
Connecting LiPo, wall wart, and project in parallel
connecting a 4 wires/lines 3.5 female jack plug with a one wired speaker
connecting the blocks of the electrical circuit of the Muller Geiger counter?

You May Also Like

Top