So I was doing some anodizing and accidentally dropped a wire (+80v) on the boost converter.....
Now i think its only the plug-in control board (see image) that got fried since the output voltage is still boosted.
Question: Can I use the control board from other MingHe boost converters? (since they are cheaper...)
Or can I buy the control board somewhere?

Thanks in advance

 

So I was doing some anodizing and accidentally dropped a wire (+80v) on the boost converter.....
Now i think its only the plug-in control board (see image) that got fried since the output voltage is still boosted.
Question: Can I use the control board from other MingHe boost converters? (since they are cheaper...)
Or can I buy the control board somewhere?

Thanks in advance

All of the MingHe units that are programmable use the same board. You can buy a B3603 unit and pop the controller out of it.