Breadboarding resistor mess

WBahn

Joined Mar 31, 2012
33,348
For surface mount parts I have small ziplock bags, about 1.5" x 2.5", that have a writable area on the front. I bought 1000 of them about a decade ago and I definitely have a lifetime supply. If I buy something from DigiKey I just cut the stocking label they include and stick it on the bag, otherwise I use a fine-point Sharpie. Then I put those in sorted order in drawers. For oddball parts I just put the bags into small boxes that have general categories written on them and stack them on a shelf such that I can read the categories. Works pretty well.
 

takao21203

Joined Apr 28, 2012
3,702
takao21203

I was referring to my personal costs. If you read the thread I pointed to I have a complete set.

I've some n thing similar for my CDs/DVDs, but nowadays I seem to be switching to thumb drives for data transport.
yes I did I think I should use a welding machine for packaging, however, the static bags can be folded too.

Welding plastic can be done with a gas soldering iron but foils melt up too fast I think they need the pressure too.

I see your technique sometimes when ordering products like small module PCBs. Its not that common but known by some people.
 

Thread Starter

nerdegutta

Joined Dec 15, 2009
2,689
So what's you best estimate on the marginal out-of-pocket cost for a box? Material cost but perhaps also an estimate of the amortized cost of the printer.
The filament used for one box is 1916mm. That is approximately 6 grams of ABS. I bought this ABS on eBay and paid $25 for 1Kg, including shipping. So material cost is next to nothing.

Printer cost:
First I made a CNC router, controlled with LinuxCNC. Then I thought it would be nice to convert that to a 3D printer. I bought an Arduino, RAMPS, Steppercontroller, hotplate and a hotend from Charlies 3D technologies in Belgium. When this printer was up an running I printed out parts for the new printer. So for this last particular printer I bought the electronics from the lowest bidder on eBay, rods, bearing, hotbed, endstops and timingbelt also from eBay, and the rest of the hardware I found in my garage. I also found a 500w ATX powersupply on eBay.

Hardware for the last printer would be something like:
Smooth and threaded rods,
Linear bearings
Hotend with heater
Arduino mega and RAMPS, step drivers and end stops
Hotplate
Timing belt with pulleys
ATX powersupply

Everything is bought with shipping included: $157

I do not remember how much filament was used to print the parts.

Plywood and other framing I found in my garage.
 
Top