I'm an absolute beginner looking to connect aN electronic cabinet latch (requiring a single .8 second 12v pulse to activate) to a push button switch. (the forum doesn't seem to allow me to post Amazon links so if you could tell me how to do that it would help)
Ideally I'd like to have it set up so that any press of the button (even if held down) only sends a single quick pulse of the .8 second 12v power (from battery or wall plus) to the switch to unlatch so that it doesn't burn out or overheat if the button stays depressed.
I have no familiarity with this stuff so any super simple solution in a compact setup with layman's terms descriptions would be wildly appreciated.
Thank you!
Ideally I'd like to have it set up so that any press of the button (even if held down) only sends a single quick pulse of the .8 second 12v power (from battery or wall plus) to the switch to unlatch so that it doesn't burn out or overheat if the button stays depressed.
I have no familiarity with this stuff so any super simple solution in a compact setup with layman's terms descriptions would be wildly appreciated.
Thank you!