All About Circuits

Altium Via Stitching

Search Forums New Posts
E

Thread Starter

engineergc

Joined Oct 21, 2016
5
Dear All;
I designed a 6 layer PCB in Altium. I placed chassis polygon to all layers. I want to place vias to provide vertical connection through the board by using stitching. But when I choose ''Add stitching to Net'' and ''Chassis'' as net, vias were placed only some parts of PCB. Empty places that don't have any pad or other component were not filled with vias. What is the reason of this problem? Regards.
 
You must log in or register to reply here.
Thread starter Similar threads Forum Replies Date
C Altium 45° Rotated Components Causing Excessive Placement Spacing PCB Layout , EDA & Simulations 2
H Altium .stackup from fab shows “Rigid (4L)” + “Flex (2L)” — is this a rigid-flex stack or a full 4-layer flex setup PCB Layout , EDA & Simulations 0
D Altium 25 Designer – Automatic ground plane cutout under SMT components (rules or scripting?) PCB Layout , EDA & Simulations 0
D Altium 25 Designer – Automatic ground plane cutout under SMT components (rules or scripting?) Software & IDEs 0
V Altium Designer: Component Clearance Constraint between Component on Top layer and Component on Bottom Layer PCB Layout , EDA & Simulations 0
Similar threads
Altium 45° Rotated Components Causing Excessive Placement Spacing
Altium .stackup from fab shows “Rigid (4L)” + “Flex (2L)” — is this a rigid-flex stack or a full 4-layer flex setup
Altium 25 Designer – Automatic ground plane cutout under SMT components (rules or scripting?)
Altium 25 Designer – Automatic ground plane cutout under SMT components (rules or scripting?)
Altium Designer: Component Clearance Constraint between Component on Top layer and Component on Bottom Layer

You May Also Like

Top