lights

Hello, First off, I'm a newbie. Not sure if what I'm looking for is doable, possible... I have 8 battery powered light fixtures. They come with 24v, 5a individual chargers. I would like to make a charger where I can charge all my (8) lights fixtures at once without the need of plugging 8...

Hey all I am currently creating a custom rain light for my car (Light on rear bumper that flashes 5 times then holds when brakes are pressed). At the moment the rain light has positive and negative connected straight onto the + and - of a brake light globe wiring. However it being super bright...

Greetings, My current project is trying to wire a headlight and two turn signals to a motorbike using a 12v rechargeable battery. There are no existing electrical parts of any kind for lighting aside from what I’m doing currently. Complete custom job. I need advice: What I have is: A switch...

2 generators are connected to the bus below. Given V1 = 300V, 50Hz V2 = 400V, 60Hz When the switch is opened, calculate i) the maximum and minimum voltage across both light 1 and 2. ii) peak voltage across both lights iii) maximum number of light pulsation How do I solve the issue above? Any...

so I took the LED strip out of my tv or to be more accurate 3 LED strips (6 bulbs each) I thought if I took a strip down to 4 I could hook it up to 12v power and it would light but I have gotten nothing, anyone willing to help me figure how to power these?

Hi I'm new to this site and yes I have very basic knowledge with electronics, I'm hoping someone here might be able to help me, I'm trying to modify my sons car by installing projector headlights but the problem I'm having is converting the lights from a dual filament (H4) to a single filament...

Building a bike. I want to run the headlight, brake light to brake lever, LED turnsignals and handle bar switch to a rechargeable 12v. No, i dont want to buy a new flywheel and coil system for the motor. I would rather swap out 2 12v and leave the engine alone. So I know little to nothing...

I have limited electrical knowledge so would like to ask if anyone can recommend a solution to a system I would like to have installed. I can have an electrician install it but as it is my concept I would like to identify the best way to configure it. We use HP air for testing at work and as a...