I have a variable frequency square wave generator that I need to amplify its output (10V). The boost circuit currently working fine with an op-amp boosting it from 10V to near 30V (using LM741 and 32V transformer).
I got an XL6009 boost module to replace the OpAmp (and get rid of the transformer)
- when I connect the square wave to the module In, the wave get distorted (attached pics before n after.. measured at module In pins) and there's is no output from the module.
- Do I need to add any extra components at the module inputs\outputs?
Attached module and wave pictures
I got an XL6009 boost module to replace the OpAmp (and get rid of the transformer)
- when I connect the square wave to the module In, the wave get distorted (attached pics before n after.. measured at module In pins) and there's is no output from the module.
- Do I need to add any extra components at the module inputs\outputs?
Attached module and wave pictures
Attachments
-
609.7 KB Views: 7
-
2.1 MB Views: 5
-
2 MB Views: 5
Last edited: