Hello guys. So I have received 2 Xbee s2 microcontrollers. They both been used by someone before. I am currently trying to configure them through X-CTU. I am also using UartSBee v.4.0 shield so I can easily connect microcontroller to PC USB. I have just finished 40 minutes scan(check screenshots) detect my Xbee but it was not able detect any devices. I have tried to scan it whilst connected to arduino but same results. Anything else should i try before i request new microcontrollers becuase these bad boys are expensive

 

Hey, Select the baud rate at 9600 and first check the compatibility between USB port of XBee and Laptop, I was facing the same issue in starting while configuring the wireless vibration sensor which is using XBee modules