I have a small turbine which is connected to a battery bank and a load. I am looking to add a simple charge controller to charge the battery until full, supply the load, and divert the power to a dump if needed. Most of all I want this to be a simple circuit that can hopefully be implemented on a breadboard. Have an of you done this before or have any ideas?
Also, I have the system relaying information to labview so one possibility that I thought of is to have labview make the decision and control the power flow.
Also, I have the system relaying information to labview so one possibility that I thought of is to have labview make the decision and control the power flow.