All About Circuits

Why my comparator output is not coming as expected.

Search Forums New Posts
H

Thread Starter

hoyyoth

Joined Mar 21, 2020
530
Hi,
I was designing a comparator circuit. The I/P to positive pin is a square wave of frequency 1khz and an amplitude of 1.4V. The reference voltage at negative input is 0.5V.

The comparator circuit is operated at 3.3V. The output of the comparator is coming as 727mV ,expected is 3.3V. The IC used is
TS3021 (https://www.st.com/en/amplifiers-and-comparators/ts3021.html#cad-resources)

1783430944674.png

1783432273223.png

May I know where I went wrong.
 

Attachments

You must log in or register to reply here.
Thread starter Similar threads Forum Replies Date
bleedfeed How to Trigger a 555 monostable With opamp output Edges Homework Help 9
tienk How to simulate the outputs of comparator and the output of the NOR gate? Homework Help 45
moonlystar1111 CT is not measuring the comparator output. Analog & Mixed-Signal Design 8
B Can I connect a common base amplifier voltage output to a commercial comparator chip directly? General Electronics Chat 5
M Triggering a comparator with a very slow RC circuit but needed fast slew on the output General Electronics Chat 31
Similar threads
How to Trigger a 555 monostable With opamp output Edges
How to simulate the outputs of comparator and the output of the NOR gate?
CT is not measuring the comparator output.
Can I connect a common base amplifier voltage output to a commercial comparator chip directly?
Triggering a comparator with a very slow RC circuit but needed fast slew on the output

You May Also Like

Top