Dear AAC,
I have a low cost alarm with a remote control ifrarouge.
This remote is useless (it's the same for all alarms all over the world !).
Currently, the remote control is necessary for the alarm to start; otherwise, she remains constantly awake.
Therefore, I would like that, as soon as the power is turned on, the alarm is in "monitoring" mode, without it being necessary to press on the remote control.
So, could you help me to achieve this ?
NOTE: The cut red wires correspond to the battery wires, but I only use the 6V plug.
Many Thanks in advance !
I have a low cost alarm with a remote control ifrarouge.
This remote is useless (it's the same for all alarms all over the world !).
Currently, the remote control is necessary for the alarm to start; otherwise, she remains constantly awake.
Therefore, I would like that, as soon as the power is turned on, the alarm is in "monitoring" mode, without it being necessary to press on the remote control.
So, could you help me to achieve this ?
NOTE: The cut red wires correspond to the battery wires, but I only use the 6V plug.
Many Thanks in advance !