Hi, everyone!
Could someone give me hand with this situation? Every time I connect a DC MOTOR R140 (see specs below) in parallel with my Lithium Battery 3.7V 2000mAh ( that is connected to the TP4056 charging module) the voltage goes to 0V - I believe this must be from the short-circuit protection IC - What can I do to solve this problem? I believe it must be some resistor to change it - what value it should be to match the motor current specification?
Could someone give me hand with this situation? Every time I connect a DC MOTOR R140 (see specs below) in parallel with my Lithium Battery 3.7V 2000mAh ( that is connected to the TP4056 charging module) the voltage goes to 0V - I believe this must be from the short-circuit protection IC - What can I do to solve this problem? I believe it must be some resistor to change it - what value it should be to match the motor current specification?