Hi,
I'm new to electronics and I have some LT1491AN, the guy who gave them them, said some are good and some are bad.
Is there any circuit that I can build to test them? Do you recommend any books or research literature to study and be possible to do the circuit?
Here is the datasheet:
Thanks
Have a nice day

 

It all depends on what test equipment you have and how fully you want to test them. If you have an oscilloscope a quick go/no-go test would be to construct the square wave oscillator circuit from the data sheet for each opamp and verify the output frequency, amplitude, and wave shape with the 'scope.

 

I don't have a oscilloscope

I was searching and found this schematic :

Is It possible for use this circuit and teste each channel?
Can I use +12 and -12 as a supply for the op amp?
I heve here a power supply that give me +12vdc, -12vdc, +5vdc and GND

Thanks

 

Yes and yes.
Again, it won't be a full test but it will separate out the completely non-functional ones.
Incidentally, if you are only connecting the resistors to one section of a multiple package at a time it would be best not to leave the others floating. Connect unused non-inverting inputs to ground and connect inverting inputs to the relevant output.