How to resolve this problem so I could simulate AC sweep with no errors !In DC steady-state analysis PSpice treats all capacitors as a open circuit and inductors as a short circuit. And this is why the nodal voltage is floating.
Skipping does not help!Or skip DC point calculation.
Also, why the hell is this a poll?
There is no errors , but ""print parts"" shows that voltages and currents are zeroes!Add 1G resistor parallel with capacitors.
AC sweep analysis linear at 1 point in start&end 50 Khz!Are you preforming AC sweep analysis ??
Thanks for help!Change into Octave and 110 points per octave.
by Jake Hertz
by Jake Hertz
by Jake Hertz
by Aaron Carman