Hello!
I need to send a signal via GPIB to the AUX OUT using a labview.
I can pass one value in volts with a command.
But I don't understand.
Do I need to write a cycle in which I will consistently transmit voltage values for each point in time?
or can I create a signal in labview (using ready-made components) and transmit it completely?
I need to send a signal via GPIB to the AUX OUT using a labview.
I can pass one value in volts with a command.
But I don't understand.
Do I need to write a cycle in which I will consistently transmit voltage values for each point in time?
or can I create a signal in labview (using ready-made components) and transmit it completely?
