Source for 6 pin connector to fit PICKit3?

Thread Starter

spinnaker

Joined Oct 29, 2009
7,830
I am trying to find the male 6 pin connector that will fit into the PICKit3. TI am odering a bunch of other parts from Mouser but the only connector that I can find looks like even close to working is not stock. I found these. Am I looking in the right place?
 

BMorse

Joined Sep 26, 2009
2,675
I am trying to find the male 6 pin connector that will fit into the PICKit3. TI am odering a bunch of other parts from Mouser but the only connector that I can find looks like even close to working is not stock. I found these. Am I looking in the right place?

These are known as SIP PIN HEADERS >> You could cross this digikey part with mouser, but I didnt see any stock... http://search.digikey.com/scripts/DkSearch/dksus.dll?Detail&name=ED7206-ND

Sometimes they come in longer pieces (more positions up to 72) and then you just break off however many pins you would need...
 

eng1

Joined Oct 25, 2009
13
I am trying to find the male 6 pin connector that will fit into the PICKit3. TI am odering a bunch of other parts from Mouser but the only connector that I can find looks like even close to working is not stock. I found these. Am I looking in the right place?
You have to search for a male 6-pin header with 0.100'' (2.54 mm) spacing. Pins must be square.

You may look at page 1392 of Mouser catalog: http://it.mouser.com/catalog/640/1392.pdf
I haven't bought the headers from them, but it looks like you can find the correct one there.
 
Top