All About Circuits

Solution to "Pad too close to Pad" #2

L

Thread Starter

lindula

Joined Sep 23, 2016
94
christiannielsen said:
Hi,

I am running Design Rules Check in KiCad/PBCNEW and I am prompted this error:
Q1-2 are transistors.

View attachment 212433

What should I do to solve this matter?
Click to expand...
Hello, I have the same problem. Where do you change that in KiCad? I am using an AD8003 and the pads are 0.25 wide and the distance between pads are 0.5.

Thank you

Moderator edit: Move to a new thread from this one:
https://forum.allaboutcircuits.com/threads/solution-to-pad-too-close-to-pad.171411/
 

Attachments

You must log in or register to reply here.
Thread starter Similar threads Forum Replies Date
P Rechargeable Battery Pack solution for a single LED Power Electronics 29
B Shaft rotation count solution needed General Electronics Chat 7
K L298N Parallel Mode - Possible Solution or Alternative Automation, Robotics & Control 18
M Need solution for jaguar v12 engine speed signal. engine swapped General Electronics Chat 18
C Solution to "Pad too close to Pad" PCB Layout , EDA & Simulations 16
Similar threads
Rechargeable Battery Pack solution for a single LED
Shaft rotation count solution needed
L298N Parallel Mode - Possible Solution or Alternative
Need solution for jaguar v12 engine speed signal. engine swapped
Solution to "Pad too close to Pad"

You May Also Like

Top