Signal Transmitted to Labview will Exhaust After Few Seconds

Thread Starter

Amalia Safiee

Joined Sep 21, 2017
9
I created a circuit to connect my arduino to function generator as I needed to test for sine wave. I managed to get the sine wave into Labview but the signal will die after few seconds but I want it to be consistent for as long as I want. Does this means I need to change or add something to my circuit? Like maybe change the value of capacitance? I used 10microFarad and 2 parallel 10k ohm resistance.

Best Regards
 

crutschow

Joined Mar 14, 2008
34,280
I see no obvious reason for the signal to fail.
What is the sinewave frequency?
Can you post pictures of the arduino output signal and the input signal to the Labview?
 
Top