All About Circuits

Signal Input Current

Search Forums New Posts
I

Thread Starter

ispymalik

Joined Apr 7, 2008
18
Hello gentleman,

I have a voltage translator supplying SPI signals to ~10 parallel devices.
how could i estimate if the translator chip can supply the required current to these devices simultaneously?

I would assume a simple RC circuit to model the input pin for each device?
 
You must log in or register to reply here.
Thread starter Similar threads Forum Replies Date
J Isolation Transformer Question for Signal Tracing with Oscilloscope General Electronics Chat 56
kiroma Introduction to Fast Analytical Techniques: Application to Small-Signal Modeling - by Christophe Basso General Electronics Chat 12
Y digital signal distortion in differential lines question Wireless & RF Design 0
A Grounding and signal distribution across multiple power supplies General Electronics Chat 14
F Adapt 0-5V sine wave signal (centered on +2.5V) to 3.3V analog read input General Electronics Chat 20
Similar threads
Isolation Transformer Question for Signal Tracing with Oscilloscope
Introduction to Fast Analytical Techniques: Application to Small-Signal Modeling - by Christophe Basso
digital signal distortion in differential lines question
Grounding and signal distribution across multiple power supplies
Adapt 0-5V sine wave signal (centered on +2.5V) to 3.3V analog read input

You May Also Like

Top