All About Circuits

Sample and hold

dl324

dl324

Joined Mar 30, 2015
16,922
Zeeus said:
Firstly, TS doesn't understand how this circuit does sample and hold
Click to expand...
The opamp is configured as a voltage follower. When Q2 is turned on, the voltage at the non-inverting input is fed back to the inverting input. When Q2 is opened, C2 holds the voltage.

When the switch is closed again, the voltage at the non-inverting input is again fed back to the inverting input.

It's important that C2 have low leakage.
 
You must log in or register to reply here.
Thread starter Similar threads Forum Replies Date
1 mn6636s ic ( aka: analog switch, de-glitcher, sample-hold, analog mux) Datasheets, Manuals & Parts Identification 2
noamshuy Bootstrap sample and hold circuit Analog & Mixed-Signal Design 0
hulage Sample and hold circuit simulation in Altium General Electronics Chat 8
T Getting started with a "sample and hold" circuit Homework Help 12
F Sample and Hold LTspice Simulation Power Electronics 2
Similar threads
mn6636s ic ( aka: analog switch, de-glitcher, sample-hold, analog mux)
Bootstrap sample and hold circuit
Sample and hold circuit simulation in Altium
Getting started with a "sample and hold" circuit
Sample and Hold LTspice Simulation

You May Also Like

Top