Hi,
I bought this remote control set, consisting of some transmitter and receiver (ZK1PA - comes with no instructions, scheme or what so ever)
Names of ports are (from diode downwards):
+ 12 V
- 12 V (GND)
NC - channel A
COM - channel A
NO - channel A
I'm trying to create a remote control for a lamp. The problem with current connection is, that when I plug the voltage source for receiver in, the lamp turns on too + when I press a button on remote control it only starts to blink unless I release the button. My goal is to make it work like this:
Plug in the voltage source for receiver
Press the button on remote control
The lamp turns on
Press the button on remote control again
The lamp turns off...
What is wrong?
For better reference of my connection, please see the picture I attached.
I would be more than grateful if someone can solve this mystery. I've been trying it myself for a week, but without any success.
I bought this remote control set, consisting of some transmitter and receiver (ZK1PA - comes with no instructions, scheme or what so ever)
Names of ports are (from diode downwards):
+ 12 V
- 12 V (GND)
NC - channel A
COM - channel A
NO - channel A
I'm trying to create a remote control for a lamp. The problem with current connection is, that when I plug the voltage source for receiver in, the lamp turns on too + when I press a button on remote control it only starts to blink unless I release the button. My goal is to make it work like this:
Plug in the voltage source for receiver
Press the button on remote control
The lamp turns on
Press the button on remote control again
The lamp turns off...
What is wrong?
For better reference of my connection, please see the picture I attached.
I would be more than grateful if someone can solve this mystery. I've been trying it myself for a week, but without any success.
Attachments
-
192.4 KB Views: 26
-
192.4 KB Views: 24