Rated conventional thermal current this applies only to heat ? and not switching current? I purchaced some switches that were supposed to be 600v- 240v- 10 amp but they are 240- 3 amp with lth 10 amp. The switches are ZB2-BE101C and I was intending on using them to switch on 3 different motors (links below) https://www.ebay.com.au/itm/3kw-4HP-2800rpm-REVERSIBLE-CSCR-Electrical-motor-single-phase-240v-compressor/181695344355?ssPageName=STRK:MEBIDX:IT&_trksid=p2060353.m2749.l2649 ................. https://www.ebay.com.au/itm/2-2kw-3-0HP-2800rpm-shaft-24mm-air-compressor-Electrical-motor-Three-phase-415v/171856843375?ssPageName=STRK:MEBIDX:IT&_trksid=p2060353.m2749.l2649 .....https://www.ebay.com.au/itm/3kw-4HP-2800rpm-REVERSIBLE-CSCR-Electrical-motor-single-phase-240v-compressor/181695344355?ssPageName=STRK:MEBIDX:IT&_trksid=p2060353.m2749.l2649 the 3 phase motor will be run through a VFD https://www.ebay.com.au/itm/220V-Variable-Frequency-Drive-VFD-Speed-Controller-for-3-phase-2-2kW-AC-Motor-AU/283119492399?ssPageName=STRK:MEBIDX:IT&_trksid=p2060353.m2749.l2649 ,,,,,,https://www.ebay.com.au/itm/Electri...m=333053767363&_trksid=p2047675.c100005.m1851
Last edited: