This project is implemented under Thonny compiler using Raspberry Pi Pico using MicroPython language
The following tasks need to be prepared before starting the project.
Hardware.
1. Raspberry Pi pico board (from: https : //www.raspberrypi.org/products/raspberry -pi-pico/)
2. 28byj-48 stepper motor (from: https://components101.com/motors/2byj-48-stepper-motor)
3. stepper motor driver circuit
4. a serial HMI display (from: https://www.stoneitech.com/)
5. a few connection lines
Compilation and debugging software: Thonny 3.3.5
The following tasks need to be prepared before starting the project.
Hardware.
1. Raspberry Pi pico board (from: https : //www.raspberrypi.org/products/raspberry -pi-pico/)
2. 28byj-48 stepper motor (from: https://components101.com/motors/2byj-48-stepper-motor)
3. stepper motor driver circuit
4. a serial HMI display (from: https://www.stoneitech.com/)
5. a few connection lines
Compilation and debugging software: Thonny 3.3.5
Last edited: