Hello guys and gays. I'm really new to the whole building a circuit stuff. Here's what I want to try to do. I can buy the item that I want but I would really like to try to build it.
I run rc crawlers and I run a winch. The problem I have is my current controller will allow the winch to creep the line out when under a load. I've read that if both wires on the winch are shorted together then that will create a brake.
I need a small device that will take my pwm signal from my receiver and allow me to have forward and reverse control along with brake.
I have a couple old servos I could take apart for some Componets. But I would really like to build something from the beginning.
I do have a dozen or so relays that take 5 volt to activate the coil. The contacts are rated for 30.
I'm just not sure how to conver the pwm signal to fire the relays.
Any help would be greatly appreciated. Thanks.
I run rc crawlers and I run a winch. The problem I have is my current controller will allow the winch to creep the line out when under a load. I've read that if both wires on the winch are shorted together then that will create a brake.
I need a small device that will take my pwm signal from my receiver and allow me to have forward and reverse control along with brake.
I have a couple old servos I could take apart for some Componets. But I would really like to build something from the beginning.
I do have a dozen or so relays that take 5 volt to activate the coil. The contacts are rated for 30.
I'm just not sure how to conver the pwm signal to fire the relays.
Any help would be greatly appreciated. Thanks.