Problem with Universal Motor Control Using a TRIAC

Thread Starter

mhm_004

Joined Sep 3, 2017
3
I have used the following circuit to control a washing machine universal motor. The problem is that after some time, the resistors in the optotriac-to-TRIAC drive path, namely R29 and R30, start to burn out, especially R29.

I have attached the datasheets for these resistors:

  • 100Ω: SR2512JK-07100RL
  • 220Ω: AS122WJ0221T4E

I have also attached the voltage waveform measured across R29.
So far, this issue has only occurred on one board that had been running under test for a few days. However, I am concerned that there might be an underlying design issue that could eventually affect other boards as well.

The circuit is based on STMicroelectronics Application Note AN5114.

I would appreciate any advice from those who have experience with this type of circuit. In particular, I would like to understand why the 100Ω resistor (R29) might be burning out.

Any ideas or suggestions would be greatly appreciated.

Thank you!
 

Attachments

Thread Starter

mhm_004

Joined Sep 3, 2017
3
Why is R90 such a low value?? That leads to a lot more current in the other two resistors.
Does the triac really require that much gate drive???
Hi @MisterBill2 , Thank you.
The resistor values recommended in the application note were even lower than the ones I'm using. Do you think using a lower resistance value could contribute to the resistor burning out?
I can't quite understand this. I replaced the burned R29 resistor on one of the boards, and it has now been running continuously, 24/7, for several days without any further problems with the resistor.
 

MaxHeadRoom

Joined Jul 18, 2013
30,884
There is a special ic out there designed by Motorola . TDA1085 for precise control of a Universal motor.
It was originally used for precice control when used in a W/ M application.
You just need to a very simple tach on the motor rear shaft.
I have used it in the past.
 
Top