All About Circuits

problem with mcp79511 xtal

Search Forums New Posts
P

Thread Starter

Picbuster

Joined Dec 2, 2013
1,062
encounter problems with mcp79511 xtal osc not running ( is activated in software).
external 32 kHz will activate rtc.
I did check xtal, resonator and cap's.
still not running.
any idea?
Picbuster
 
Z

ZiloaRD

Joined Sep 11, 2017
1
We had a similar issue, it was caused by CONTROL, EXTOSC bit. It should be 0 at power on reset, but on some occasions it can spuriously become 1 (External oscillator mode).
 
You must log in or register to reply here.
Thread starter Similar threads Forum Replies Date
M Honda ES5500/EX5500 Generators Hi all i have a few of these generators that i need to fix the problem like lot of people the AVRs General Electronics Chat 3
M ESP32P4 - UART TX problem Microcontrollers 2
Y solderless sma screw mounting RF causaliy problem PCB Layout , EDA & Simulations 1
Vilius_Zalenas Strange MOSFET operating point problem in linear regulator setup Analog & Mixed-Signal Design 9
P MCP79511 EEPROM write problem Microcontrollers 3
Similar threads
Honda ES5500/EX5500 Generators Hi all i have a few of these generators that i need to fix the problem like lot of people the AVRs
ESP32P4 - UART TX problem
solderless sma screw mounting RF causaliy problem
Strange MOSFET operating point problem in linear regulator setup
MCP79511 EEPROM write problem

You May Also Like

Top