I have a Phillips dream station 2 cpap that quit working. I can see a burn mark on the circuit board. I cleaned everything up but it’s still not working. There are no service parts available.
I can’t sleep without it and it may be a few weeks before I can get a new machine. Is it possible to repair this board and what would I need?
The cpap turns on fine and goes to the main menu correctly. However,when pressing the button to start the “air” blowing its like it gets stuck in a boot loop and does this about 3 times then gives me an error message. Any help would be greatly appreciated!

 

Anyone??

 

...does this about 3 times then gives me an error message.

.....and what is the error message?

 

.....and what is the error message?

Something about service needed

 

it looks to have liquid damage. I dont think anyone will be able to guide you through any time of repair with it if you have no experience with that type of work.

 

it looks to have liquid damage. I dont think anyone will be able to guide you through any time of repair with it if you have no experience with that type of work.

I have some. I am assuming that transistor needs replaced. How would I go about finding a proper replacement with no markings on it.

 

q3?
looks like it would be same as q2 & q3 to me. All 3 are same layout.

It has a ton of liquid damage though. Many of the smd components are going to be heavily oxidized. Q3 is the least of your problems.

 

Where else do you see damage? Can you tell what q2 and 3 are?