Hi,
I'm drawing a PCB in which I need to include the module ESP32 Lora, as shown below:
What I intend to do is to construct a kind of shield so I can just plug the board into the PCB. To do that I will need two single row 18 pins female headers as shown below:
I guess they are 2.54mm Pitch.
I'm trying to find a proper drawing to see the dimensions and length between the two headers. However, I only found this:
It doesn't actually show the length between the holes of both connectors. Maybe I'm misunderstanding the drawing. Any suggestions?
I'm drawing a PCB in which I need to include the module ESP32 Lora, as shown below:
What I intend to do is to construct a kind of shield so I can just plug the board into the PCB. To do that I will need two single row 18 pins female headers as shown below:
I guess they are 2.54mm Pitch.
I'm trying to find a proper drawing to see the dimensions and length between the two headers. However, I only found this:
It doesn't actually show the length between the holes of both connectors. Maybe I'm misunderstanding the drawing. Any suggestions?