Hello everyone, I would appreciate some assistance in reviewing my PCB project. I am developing a project using the w5500, and I used the schematic available at https://docs.wiznet.io/img/products/w5500/w5500_sch_v110_use_trans_.pdf to develop it, with some modifications. As this is my first project using the w5500, I would appreciate some help in reviewing whether my layout and schematic will work. Sorry for my poor English.

Connector RJ45
https://cdn.amphenol-cs.com/media/wysiwyg/files/drawing/p-rje88-188-0xxx.pdf

 

Is that using Kicad?
I am surprised you did not get an error for not using a power flag.
Did it pass the ERC check?

 

Is that using Kicad?
I am surprised you did not get an error for not using a power flag.
Did it pass the ERC check?

Yes, I am using Kicad. The project has several pages, and ERC tests only showed errors on other pages, which are still under development.

 

update

 

linkled and Actled both need ID flags both ends e.g.



Also I don't see any power flags

Power flag